M7350/kernel/Documentation/devicetree/bindings/regulator/gdsc-regulator.txt

Qualcomm Global Distributed Switch Controller (GDSC) Regulator Driver

The GDSC driver, implemented under the regulator framework, is responsible for
safely collapsing and restoring power to peripheral cores on chipsets like
msm8974 for power savings.

Required properties:
 - compatible:      Must be "qcom,gdsc"
 - regulator-name:  A string used as a descriptive name for regulator outputs
 - reg:             The address of the GDSCR register

Optional properties:
 - parent-supply:   phandle to the parent supply/regulator node
 - clock-names:     List of string names for core clocks
 - qcom,retain-mem:  Presence denotes a hardware requirement to leave the
		     forced core memory retention signals in the core's clock
		     branch control registers asserted.
 - qcom,retain-periph: Presence denotes a hardware requirement to leave the
		     forced periph memory retention signal in the core's clock
		     branch control registers asserted.
 - qcom,skip-logic-collapse: Presence denotes a requirement to leave power to
                             the core's logic enabled.
 - qcom,support-hw-trigger: Presence denotes a hardware feature to switch
			    on/off this regulator based on internal HW signals
			    to save more power.
 - qcom,enable-root-clk: Presence denotes that the clocks in the "clocks"
			property are required to be enabled before gdsc is
			turned on and disabled before turning off gdsc. This
			will be used in subsystems where reset is synchronous
			and root clk is active without sw being aware of its
			state. The clock-name which denotes the root clock
			should be named as "core_root_clk".
 - qcom,force-enable-root-clk: If set, denotes that the root clock should be
			force enabled before turning on the GDSC and then be
			immediately force disabled. Likewise for GDSC disable.
			This is used in cases where the core root clock needs
			to be force-enabled prior to turning on the core. The
			clock-name which denotes the root clock should be
			"core_root_clk".
 - qcom,clk-dis-wait-val: Input value for CLK_DIS_WAIT controls state transition
			 delay after halting clock in the collapsible core.
 - reg-names:		Names of the bases for the above "reg" registers.
			Ex. "base", "domain_addr".
 - qcom,no-status-check-on-disable: Do not poll the status bit when GDSC
			is disabled.
 - qcom,disallow-clear: Presence denotes the periph & core memory will not be
			cleared, unless the required subsystem does not invoke
			the api which will allow clearing the bits.
 - qcom,gds-timeout:	Maximum time (in usecs) that might be taken by a GDSC
			to enable.

Example:
	gdsc_oxili_gx: qcom,gdsc@fd8c4024 {
		compatible = "qcom,gdsc";
		regulator-name = "gdsc_oxili_gx";
		parent-supply = <&pm8841_s4>;
		reg = <0xfd8c4024 0x4>;
		clock-names = "core_clk";
	};