41 lines
1.5 KiB
Plaintext
41 lines
1.5 KiB
Plaintext
* Power Management boot configuration (pm-boot)
|
|
|
|
Low power management drivers need to specify the warmboot entry path for the
|
|
application processors to resume from sleep/suspend. The boot configuration
|
|
can vary if the core does/does not support a secure boot mode. The secure
|
|
boot configuration boots the core sets up the core sub system registers and
|
|
calls into the kernel entry point. In the absence of a secure boot mode, the
|
|
core when powered on from reset will need to be configured with the warmboot
|
|
entry pointer. The physical and the virtual address for the entry pointer
|
|
need to provided to the driver.
|
|
|
|
|
|
The device tree parameters for pm-boot are:
|
|
|
|
Required parameters:
|
|
|
|
- compatible: Must be "qcom,pm-boot"
|
|
- qcom,mode: The mode that the target will use for booting
|
|
"tz" = MSM_PM_BOOT_CONFIG_TZ,
|
|
"reset_vector_phys" = MSM_PM_BOOT_CONFIG_RESET_VECTOR_PHYS,
|
|
"reset_vector_virt" = MSM_PM_BOOT_CONFIG_RESET_VECTOR_VIRT,
|
|
"remap_boot_addr" = MSM_PM_BOOT_CONFIG_REMAP_BOOT_ADDR,
|
|
|
|
Optional parameters (based on the mode chosen):
|
|
|
|
- qcom,phy-addr: The physical address that will be used for warmboot entry if
|
|
the processor remap register can be programmed.
|
|
Needed for modes = { MSM_PM_BOOT_CONFIG_RESET_VECTOR_PHYS,
|
|
MSM_PM_BOOT_CONFIG_REMAP_BOOT_ADDR }
|
|
- qcom,virt-addr: The virtual address at which the processor start booting from
|
|
Needed for modes = { MSM_PM_BOOT_CONFIG_RESET_VECTOR_VIRT,
|
|
MSM_PM_BOOT_CONFIG_REMAP_BOOT_ADDR }
|
|
|
|
|
|
Example:
|
|
|
|
qcom,pm-boot {
|
|
compatible = "qcom,pm-boot";
|
|
qcom,mode = "tz"; /* MSM_PM_BOOT_CONFIG_TZ */
|
|
};
|