45 lines
1.4 KiB
Plaintext
45 lines
1.4 KiB
Plaintext
TI DRV2667 is a haptic controller chip. It can drive piezo haptics
|
|
and can operate in two modes - analog and digital.
|
|
|
|
Required properties:
|
|
|
|
-compatible : should be "ti,drv2667".
|
|
-reg : i2c address to be used.
|
|
-vdd-supply : regulator to power the chip.
|
|
-vdd-i2c-supply : regulator to power i2c bus.
|
|
|
|
Optional properties:
|
|
|
|
-ti,label : Name to be registered with timedoutput class.
|
|
-ti,mode : Mode to be supported, 0 to 3 - FIFO, RAM, WAVE and ANALOG.
|
|
-ti,wav-seq : Wave Sequence composed of 11 bytes - wave form id,
|
|
Header size, start upper byte, start lower byte,
|
|
stop upper byte, stop lower byte, repeat count,
|
|
amplitude, frequency, duration and envelope
|
|
-ti,gain : Gain to be programmed for the chip.
|
|
-ti,idle-timeout-ms : Idle timeout in ms to be programmed for the chip to go into
|
|
low power mode after finishing its operation.
|
|
-ti,max-runtime-ms : Maximum time in ms for which chip can drive haptics.
|
|
|
|
Example:
|
|
i2c@f9967000 {
|
|
ti-drv2667@59 {
|
|
compatible = "ti,drv2667";
|
|
reg = <0x59>;
|
|
vdd-supply = <&drv2667_vreg>;
|
|
vdd-i2c-supply = <&pm8941_s3>;
|
|
ti,label = "vibrator";
|
|
ti,gain = <3>;
|
|
ti,idle-timeout-ms = <20>;
|
|
ti,max-runtime-ms = <15000>;
|
|
ti,mode = <2>;
|
|
ti,wav-seq = [
|
|
/* wave form id */
|
|
01
|
|
/* header size, start and stop bytes */
|
|
05 80 06 00 09
|
|
/* repeat, amp, freq, duration, envelope */
|
|
01 ff 19 02 00];
|
|
};
|
|
};
|