67 lines
1.7 KiB
Plaintext
67 lines
1.7 KiB
Plaintext
Samsung LD9040 AMOLED LCD parallel RGB panel with SPI control bus
|
|
|
|
Required properties:
|
|
- compatible: "samsung,ld9040"
|
|
- reg: address of the panel on SPI bus
|
|
- vdd3-supply: core voltage supply
|
|
- vci-supply: voltage supply for analog circuits
|
|
- reset-gpios: a GPIO spec for the reset pin
|
|
- display-timings: timings for the connected panel according to [1]
|
|
|
|
The panel must obey rules for SPI slave device specified in document [2].
|
|
|
|
Optional properties:
|
|
- power-on-delay: delay after turning regulators on [ms]
|
|
- reset-delay: delay after reset sequence [ms]
|
|
- panel-width-mm: physical panel width [mm]
|
|
- panel-height-mm: physical panel height [mm]
|
|
|
|
The device node can contain one 'port' child node with one child
|
|
'endpoint' node, according to the bindings defined in [3]. This
|
|
node should describe panel's video bus.
|
|
|
|
[1]: Documentation/devicetree/bindings/video/display-timing.txt
|
|
[2]: Documentation/devicetree/bindings/spi/spi-bus.txt
|
|
[3]: Documentation/devicetree/bindings/media/video-interfaces.txt
|
|
|
|
Example:
|
|
|
|
lcd@0 {
|
|
compatible = "samsung,ld9040";
|
|
reg = <0>;
|
|
vdd3-supply = <&ldo7_reg>;
|
|
vci-supply = <&ldo17_reg>;
|
|
reset-gpios = <&gpy4 5 0>;
|
|
spi-max-frequency = <1200000>;
|
|
spi-cpol;
|
|
spi-cpha;
|
|
power-on-delay = <10>;
|
|
reset-delay = <10>;
|
|
panel-width-mm = <90>;
|
|
panel-height-mm = <154>;
|
|
|
|
display-timings {
|
|
timing {
|
|
clock-frequency = <23492370>;
|
|
hactive = <480>;
|
|
vactive = <800>;
|
|
hback-porch = <16>;
|
|
hfront-porch = <16>;
|
|
vback-porch = <2>;
|
|
vfront-porch = <28>;
|
|
hsync-len = <2>;
|
|
vsync-len = <1>;
|
|
hsync-active = <0>;
|
|
vsync-active = <0>;
|
|
de-active = <0>;
|
|
pixelclk-active = <0>;
|
|
};
|
|
};
|
|
|
|
port {
|
|
lcd_ep: endpoint {
|
|
remote-endpoint = <&fimd_dpi_ep>;
|
|
};
|
|
};
|
|
};
|