/* * linux/include/linux/mmc/sdhci.h - Secure Digital Host Controller Interface * * Copyright (C) 2005-2008 Pierre Ossman, All Rights Reserved. * * This program is free software; you can redistribute it and/or modify * it under the terms of the GNU General Public License as published by * the Free Software Foundation; either version 2 of the License, or (at * your option) any later version. */ #ifndef LINUX_MMC_SDHCI_H #define LINUX_MMC_SDHCI_H #include #include #include #include #include #include struct sdhci_next { unsigned int sg_count; s32 cookie; }; struct sdhci_host { /* Data set by hardware interface driver */ const char *hw_name; /* Hardware bus name */ unsigned int quirks; /* Deviations from spec. */ /* Controller doesn't honor resets unless we touch the clock register */ #define SDHCI_QUIRK_CLOCK_BEFORE_RESET (1<<0) /* Controller has bad caps bits, but really supports DMA */ #define SDHCI_QUIRK_FORCE_DMA (1<<1) /* Controller doesn't like to be reset when there is no card inserted. */ #define SDHCI_QUIRK_NO_CARD_NO_RESET (1<<2) /* Controller doesn't like clearing the power reg before a change */ #define SDHCI_QUIRK_SINGLE_POWER_WRITE (1<<3) /* Controller has flaky internal state so reset it on each ios change */ #define SDHCI_QUIRK_RESET_CMD_DATA_ON_IOS (1<<4) /* Controller has an unusable DMA engine */ #define SDHCI_QUIRK_BROKEN_DMA (1<<5) /* Controller has an unusable ADMA engine */ #define SDHCI_QUIRK_BROKEN_ADMA (1<<6) /* Controller can only DMA from 32-bit aligned addresses */ #define SDHCI_QUIRK_32BIT_DMA_ADDR (1<<7) /* Controller can only DMA chunk sizes that are a multiple of 32 bits */ #define SDHCI_QUIRK_32BIT_DMA_SIZE (1<<8) /* Controller can only ADMA chunks that are a multiple of 32 bits */ #define SDHCI_QUIRK_32BIT_ADMA_SIZE (1<<9) /* Controller needs to be reset after each request to stay stable */ #define SDHCI_QUIRK_RESET_AFTER_REQUEST (1<<10) /* Controller needs voltage and power writes to happen separately */ #define SDHCI_QUIRK_NO_SIMULT_VDD_AND_POWER (1<<11) /* Controller provides an incorrect timeout value for transfers */ #define SDHCI_QUIRK_BROKEN_TIMEOUT_VAL (1<<12) /* Controller has an issue with buffer bits for small transfers */ #define SDHCI_QUIRK_BROKEN_SMALL_PIO (1<<13) /* Controller does not provide transfer-complete interrupt when not busy */ #define SDHCI_QUIRK_NO_BUSY_IRQ (1<<14) /* Controller has unreliable card detection */ #define SDHCI_QUIRK_BROKEN_CARD_DETECTION (1<<15) /* Controller reports inverted write-protect state */ #define SDHCI_QUIRK_INVERTED_WRITE_PROTECT (1<<16) /* Controller has nonstandard clock management */ #define SDHCI_QUIRK_NONSTANDARD_CLOCK (1<<17) /* Controller does not like fast PIO transfers */ #define SDHCI_QUIRK_PIO_NEEDS_DELAY (1<<18) /* Controller losing signal/interrupt enable states after reset */ #define SDHCI_QUIRK_RESTORE_IRQS_AFTER_RESET (1<<19) /* Controller has to be forced to use block size of 2048 bytes */ #define SDHCI_QUIRK_FORCE_BLK_SZ_2048 (1<<20) /* Controller cannot do multi-block transfers */ #define SDHCI_QUIRK_NO_MULTIBLOCK (1<<21) /* Controller can only handle 1-bit data transfers */ #define SDHCI_QUIRK_FORCE_1_BIT_DATA (1<<22) /* Controller needs 10ms delay between applying power and clock */ #define SDHCI_QUIRK_DELAY_AFTER_POWER (1<<23) /* Controller uses SDCLK instead of TMCLK for data timeouts */ #define SDHCI_QUIRK_DATA_TIMEOUT_USES_SDCLK (1<<24) /* Controller reports wrong base clock capability */ #define SDHCI_QUIRK_CAP_CLOCK_BASE_BROKEN (1<<25) /* Controller cannot support End Attribute in NOP ADMA descriptor */ #define SDHCI_QUIRK_NO_ENDATTR_IN_NOPDESC (1<<26) /* Controller is missing device caps. Use caps provided by host */ #define SDHCI_QUIRK_MISSING_CAPS (1<<27) /* Controller uses Auto CMD12 command to stop the transfer */ #define SDHCI_QUIRK_MULTIBLOCK_READ_ACMD12 (1<<28) /* Controller doesn't have HISPD bit field in HI-SPEED SD card */ #define SDHCI_QUIRK_NO_HISPD_BIT (1<<29) /* Controller treats ADMA descriptors with length 0000h incorrectly */ #define SDHCI_QUIRK_BROKEN_ADMA_ZEROLEN_DESC (1<<30) /* The read-only detection via SDHCI_PRESENT_STATE register is unstable */ #define SDHCI_QUIRK_UNSTABLE_RO_DETECT (1<<31) unsigned int quirks2; /* More deviations from spec. */ #define SDHCI_QUIRK2_HOST_OFF_CARD_ON (1<<0) /* * Read Transfer Active/ Write Transfer Active may be not * de-asserted after end of transaction. Issue reset for DAT line. */ #define SDHCI_QUIRK2_RDWR_TX_ACTIVE_EOT (1<<1) /* * Slow interrupt clearance at 400KHz may cause * host controller driver interrupt handler to * be called twice. */ #define SDHCI_QUIRK2_SLOW_INT_CLR (1<<2) /* Ignore CMD CRC errors for tuning commands */ #define SDHCI_QUIRK2_IGNORE_CMDCRC_FOR_TUNING (1<<3) /* * If the base clock can be scalable, then there should be no further * clock dividing as the input clock itself will be scaled down to * required frequency. */ #define SDHCI_QUIRK2_ALWAYS_USE_BASE_CLOCK (1<<4) /* * Dont use the max_discard_to in sdhci driver so that the maximum discard * unit gets picked by the mmc queue. Otherwise, it takes a long time for * secure discard kind of operations to complete. */ #define SDHCI_QUIRK2_USE_MAX_DISCARD_SIZE (1<<5) /* * Ignore data timeout error for R1B commands as there will be no * data associated and the busy timeout value for these commands * could be lager than the maximum timeout value that controller * can handle. */ #define SDHCI_QUIRK2_IGNORE_DATATOUT_FOR_R1BCMD (1<<6) /* * The preset value registers are not properly initialized by * some hardware and hence preset value must not be enabled for * such controllers. */ #define SDHCI_QUIRK2_BROKEN_PRESET_VALUE (1<<7) /* * Some controllers define the usage of 0xF in data timeout counter * register (0x2E) which is actually a reserved bit as per * specification. */ #define SDHCI_QUIRK2_USE_RESERVED_MAX_TIMEOUT (1<<8) int irq; /* Device IRQ */ void __iomem *ioaddr; /* Mapped address */ const struct sdhci_ops *ops; /* Low level hw interface */ struct regulator *vmmc; /* Power regulator */ /* Internal data */ struct mmc_host *mmc; /* MMC structure */ u64 dma_mask; /* custom DMA mask */ #if defined(CONFIG_LEDS_CLASS) || defined(CONFIG_LEDS_CLASS_MODULE) struct led_classdev led; /* LED control */ char led_name[32]; #endif spinlock_t lock; /* Mutex */ int flags; /* Host attributes */ #define SDHCI_USE_SDMA (1<<0) /* Host is SDMA capable */ #define SDHCI_USE_ADMA (1<<1) /* Host is ADMA capable */ #define SDHCI_REQ_USE_DMA (1<<2) /* Use DMA for this req. */ #define SDHCI_DEVICE_DEAD (1<<3) /* Device unresponsive */ #define SDHCI_SDR50_NEEDS_TUNING (1<<4) /* SDR50 needs tuning */ #define SDHCI_NEEDS_RETUNING (1<<5) /* Host needs retuning */ #define SDHCI_AUTO_CMD12 (1<<6) /* Auto CMD12 support */ #define SDHCI_AUTO_CMD23 (1<<7) /* Auto CMD23 support */ #define SDHCI_PV_ENABLED (1<<8) /* Preset value enabled */ #define SDHCI_SDIO_IRQ_ENABLED (1<<9) /* SDIO irq enabled */ #define SDHCI_HS200_NEEDS_TUNING (1<<10) /* HS200 needs tuning */ unsigned int version; /* SDHCI spec. version */ unsigned int max_clk; /* Max possible freq (MHz) */ unsigned int timeout_clk; /* Timeout freq (KHz) */ unsigned int clk_mul; /* Clock Muliplier value */ unsigned int clock; /* Current clock (MHz) */ u8 pwr; /* Current voltage */ bool runtime_suspended; /* Host is runtime suspended */ struct mmc_request *mrq; /* Current request */ struct mmc_command *cmd; /* Current command */ struct mmc_data *data; /* Current data request */ unsigned int data_early:1; /* Data finished before cmd */ struct sg_mapping_iter sg_miter; /* SG state for PIO */ unsigned int blocks; /* remaining PIO blocks */ int sg_count; /* Mapped sg entries */ u8 *adma_desc; /* ADMA descriptor table */ u8 *align_buffer; /* Bounce buffer */ unsigned int adma_desc_sz; /* ADMA descriptor table size */ unsigned int align_buf_sz; /* Bounce buffer size */ unsigned int adma_max_desc; /* Max ADMA descriptos (max sg segments) */ dma_addr_t adma_addr; /* Mapped ADMA descr. table */ dma_addr_t align_addr; /* Mapped bounce buffer */ struct tasklet_struct card_tasklet; /* Tasklet structures */ struct tasklet_struct finish_tasklet; struct timer_list timer; /* Timer for timeouts */ unsigned int caps; /* Alternative capabilities */ unsigned int ocr_avail_sdio; /* OCR bit masks */ unsigned int ocr_avail_sd; unsigned int ocr_avail_mmc; wait_queue_head_t buf_ready_int; /* Waitqueue for Buffer Read Ready interrupt */ unsigned int tuning_done; /* Condition flag set when CMD19 succeeds */ unsigned int tuning_count; /* Timer count for re-tuning */ unsigned int tuning_mode; /* Re-tuning mode supported by host */ #define SDHCI_TUNING_MODE_1 0 struct timer_list tuning_timer; /* Timer for tuning */ unsigned int cpu_dma_latency_us; struct pm_qos_request pm_qos_req_dma; struct sdhci_next next_data; ktime_t data_start_time; unsigned long private[0] ____cacheline_aligned; }; #endif /* LINUX_MMC_SDHCI_H */