30 lines
1.1 KiB
Plaintext
30 lines
1.1 KiB
Plaintext
|
* MTD SPI driver for ST M25Pxx (and similar) serial flash chips
|
||
|
|
|
||
|
|
Required properties:
|
||
|
|
- #address-cells, #size-cells : Must be present if the device has sub-nodes
|
||
|
|
representing partitions.
|
||
|
|
- compatible : Should be the manufacturer and the name of the chip. Bear in mind
|
||
|
|
the DT binding is not Linux-only, but in case of Linux, see the
|
||
|
|
"spi_nor_ids" table in drivers/mtd/spi-nor/spi-nor.c for the list
|
||
|
|
of supported chips.
|
||
|
|
- reg : Chip-Select number
|
||
|
|
- spi-max-frequency : Maximum frequency of the SPI bus the chip can operate at
|
||
|
|
|
||
|
|
Optional properties:
|
||
|
|
- m25p,fast-read : Use the "fast read" opcode to read data from the chip instead
|
||
|
|
of the usual "read" opcode. This opcode is not supported by
|
||
|
|
all chips and support for it can not be detected at runtime.
|
||
|
|
Refer to your chips' datasheet to check if this is supported
|
||
|
|
by your chip.
|
||
|
|
|
||
|
|
Example:
|
||
|
|
|
||
|
|
flash: m25p80@0 {
|
||
|
|
#address-cells = <1>;
|
||
|
|
#size-cells = <1>;
|
||
|
|
compatible = "spansion,m25p80";
|
||
|
|
reg = <0>;
|
||
|
|
spi-max-frequency = <40000000>;
|
||
|
|
m25p,fast-read;
|
||
|
|
};
|