108 lines
3.4 KiB
C
108 lines
3.4 KiB
C
|
/* Copyright (c) 2012-2013, The Linux Foundation. All rights reserved.
|
||
|
|
||
|
* Redistribution and use in source and binary forms, with or without
|
||
|
* modification, are permitted provided that the following conditions are
|
||
|
* met:
|
||
|
* * Redistributions of source code must retain the above copyright
|
||
|
* notice, this list of conditions and the following disclaimer.
|
||
|
* * Redistributions in binary form must reproduce the above
|
||
|
* copyright notice, this list of conditions and the following
|
||
|
* disclaimer in the documentation and/or other materials provided
|
||
|
* with the distribution.
|
||
|
* * Neither the name of The Linux Foundation, Inc. nor the names of its
|
||
|
* contributors may be used to endorse or promote products derived
|
||
|
* from this software without specific prior written permission.
|
||
|
*
|
||
|
* THIS SOFTWARE IS PROVIDED "AS IS" AND ANY EXPRESS OR IMPLIED
|
||
|
* WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
|
||
|
* MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-INFRINGEMENT
|
||
|
* ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT OWNER OR CONTRIBUTORS
|
||
|
* BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
|
||
|
* CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
|
||
|
* SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR
|
||
|
* BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY,
|
||
|
* WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE
|
||
|
* OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN
|
||
|
* IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
|
||
|
*/
|
||
|
|
||
|
#ifndef _PM8x41_H_
|
||
|
#define _PM8x41_H_
|
||
|
|
||
|
#include <sys/types.h>
|
||
|
|
||
|
#define PM_GPIO_DIR_OUT 0x01
|
||
|
#define PM_GPIO_DIR_IN 0x00
|
||
|
#define PM_GPIO_DIR_BOTH 0x02
|
||
|
|
||
|
#define PM_GPIO_PULL_UP_30 0
|
||
|
#define PM_GPIO_PULL_UP_1_5 1
|
||
|
#define PM_GPIO_PULL_UP_31_5 2
|
||
|
/* 1.5uA + 30uA boost */
|
||
|
#define PM_GPIO_PULL_UP_1_5_30 3
|
||
|
#define PM_GPIO_PULL_RESV_1 4
|
||
|
#define PM_GPIO_PULL_RESV_2 5
|
||
|
|
||
|
|
||
|
#define PM_GPIO_OUT_CMOS 0x00
|
||
|
#define PM_GPIO_OUT_DRAIN_NMOS 0x01
|
||
|
#define PM_GPIO_OUT_DRAIN_PMOS 0x02
|
||
|
|
||
|
#define PM_GPIO_OUT_DRIVE_LOW 0x01
|
||
|
#define PM_GPIO_OUT_DRIVE_MED 0x02
|
||
|
#define PM_GPIO_OUT_DRIVE_HIGH 0x03
|
||
|
|
||
|
|
||
|
#define PM_GPIO_FUNC_LOW 0x00
|
||
|
#define PM_GPIO_FUNC_HIGH 0x01
|
||
|
|
||
|
#define PM_GPIO_MODE_MASK 0x70
|
||
|
#define PM_GPIO_OUTPUT_MASK 0x0F
|
||
|
|
||
|
#define PON_PSHOLD_WARM_RESET 0x1
|
||
|
#define PON_PSHOLD_SHUTDOWN 0x4
|
||
|
|
||
|
#define PMIC_VERSION_V2 1
|
||
|
|
||
|
/*Target power on reasons*/
|
||
|
#define DC_CHG 8
|
||
|
#define USB_CHG 16
|
||
|
#define PON1 32
|
||
|
#define CBLPWR_N 64
|
||
|
#define KPDPWR_N 128
|
||
|
|
||
|
struct pm8x41_gpio {
|
||
|
int direction;
|
||
|
int output_buffer;
|
||
|
int output_value;
|
||
|
int pull;
|
||
|
int vin_sel;
|
||
|
int out_strength;
|
||
|
int function;
|
||
|
int inv_int_pol;
|
||
|
int disable_pin;
|
||
|
};
|
||
|
|
||
|
int pm8x41_gpio_get(uint8_t gpio, uint8_t *status);
|
||
|
int pm8x41_gpio_set(uint8_t gpio, uint8_t value);
|
||
|
int pm8x41_gpio_config(uint8_t gpio, struct pm8x41_gpio *config);
|
||
|
void pm8x41_set_boot_done();
|
||
|
uint32_t pm8x41_resin_status();
|
||
|
uint32_t pm8x41_resin_bark_workaround_status();
|
||
|
void pm8x41_reset_configure(uint8_t);
|
||
|
void pm8x41_v2_reset_configure(uint8_t);
|
||
|
int pm8x41_ldo_set_voltage(const char *, uint32_t);
|
||
|
int pm8x41_ldo_control(const char *, uint8_t);
|
||
|
uint8_t pm8x41_get_pmic_rev();
|
||
|
uint8_t pm8x41_get_pon_reason();
|
||
|
|
||
|
struct pm8x41_ldo {
|
||
|
const char *name;
|
||
|
uint8_t type;
|
||
|
uint32_t base;
|
||
|
uint32_t range_reg;
|
||
|
uint32_t step_reg;
|
||
|
uint32_t enable_reg;
|
||
|
};
|
||
|
#endif
|